1, the network fee is to be paid every month, of course, you can also go to businessThe office has a certain amount of money in advance, and the network will be disconnected if you fail to pay it.
2. Wi-fi? Broadband Internet. Broadband is paid by the hour no matter how much data. You know, when you say anything. Broadband plus a wireless router is a wireless network.
3, no wireless router does not need to pay every month: The router is a hardware device, no monthly payment after purchase.
4, as long as the home broadband has been paid normally, WIFI can be used, no money. WiFi routers actually convert wired network signals into wireless signals through WiFi wireless routersThe network will automatically recover within a few hours.
WiFi can not be used after the broadband arrearage is paid, usually because the network service needs to be reactivated or there is a problem with the device configuration. First of all, the Internet service provider may suspend the service after the broadband is overdue, and it takes a certain amount of time to restore the service even if the back fee is paid. This process may involve the update of the background system and the reactivation of the account.
After paying the network fee, the wifi display cannot be accessed, and the reasons are as follows: The mobile phone wifi has been connected and cannot be accessed after the problem appears, the first test is whether the mobile phone itself is suddenQuestion, you can shut down and restart the connection to see if such a situation still occurs. Or use other phones or devices to connect to WiFi to try to get online and eliminate the problem of WiFi itself.
The reason why Wi-Fi can not be connected to the Internet is: because of unpaid fees, the account is automatically closed by the background billing system, such as the failure to connect to broadband after broadband arrearage payment, may be a system delay problem. The possible causes for Wi-Fi access failure are as follows: If the network cable is loose, insert both ends of the network cable tightly. If the equipment is used for a long time, the optical cat, router, computer and other Internet equipment can be powered off10-20 seconds, then power on and restart.
Because of the arrearage, has been shut down, after the renewal of the opening to have a time process, not the renewal of the opening. As long as the router is turned on, there is a wireless signal, and your original wireless device can be connected, but your broadband has not been opened, so the router is not connected to the Internet.
1, connect the broadband cat or home network cable to the router WLAN interface, and then connect the computer through the network cable or wireless network. Use the computer to open the browser, enter the router management page address in the browser address bar, you can refer to the manual to find, generally 19161. After entering the page, you will be prompted to enter the management account, which also needs to be found in the manual, and the password of the general account is admin.
2, first check the gateway of the original device, such as the result is 19160.1, then the computer is connected to no lineBy the LAN port, do not connect to other devices, enter 19160.1 in the browser address bar, enter the router management interface, modify the wireless router IP address in the LAN port item, such as 19160.66, save and restart after access to the LAN can be. Note that the network cable must be connected to the LAN port.
3, light cat connected to the computer needs a broadband connection. Enter the IP address on the back of the router account password to enter the management interface -- click the setup wizard --PPPOE-- Enter the broadband account password -- enter the WIFI password. 2: The optical cat is connected to powerThe brain doesn't need a broadband connection.
4. If you need to use a computer or mobile phone to access the Internet through a router, set it as follows: Connect the network cable of the LAN port of the MODEM to the WAN port of the router through wired Settings, and then connect the LAN port to the NIC port of the computer through the network cable. Enter IP address 19XXX.XXX.XXX in the Internet Explorer address box and press Enter. The login window is displayed. After entering the user name and password, you can enter the configuration interface.