1, the network wiring in the hotel room is usually a combination of wireless and wired. Wireless Wi-Fi coverage is a basic requirement to ensure guests can use the wireless network smoothly in the room. For guests who need a wired connection, such as business people or gamers, Internet access will also be provided in the room so that they can plug in the cable directly and enjoy a more stable Internet connection.
2, the wired wiring transmits signals through the line, and the control center is closely connected with the equipment in the room. This way the signal is stable, but requires careful line planningCircuit layout, including power lines, control lines and signal lines. The power line should be safe, the control line should use a wire with strong anti-interference ability, and the signal line should choose an appropriate signal transmission mode according to the transmission mode supported by the device, such as Bluetooth, Wi-Fi, Zigbee, etc.
3, secondly, in the wiring process, it is necessary to pay attention to the safety and concealment of the line. The line should be hidden as far as possible in places that are not easy to be detected, such as the ceiling, the wall or the ground, to avoid affecting the beauty of the room. At the same time, the line should adopt the wire and equipment that meet the safety standards, and do a good job of moisture-proof and lightening protectionTake out the fasteners, take out the original car's silicone pad, and remove and take out the two USB cables. Put in the purchased wireless charging board, and the two USB ports on the wireless charging board need to pass through the two holes in the cover plate to reach the bottom. And put the retainer back on.
2, set the wireless reverse charging open to manual open, that is, it must be opened manually in the setting. Huawei car automatic sensor wireless charger can open and close intelligent, so the aseptic bumpy road conditions, built-in infrared sensor, the mobile phone is close, the clamping arm automatically opens and closes, the strong clamping force of the mobile phone is not easy to fall off, and can easily cope with various bumps. Touch the left sensor button to unlock easily, turn off the engineThe status phone can be taken out manually, so that the operation is convenient and the room is collected freely.
3, first of all, find and remove hidden screws, Mercedes-Benz c car radio charger device will be covered under the panel or other easily overlooked location, need to find and remove any fixed devices, such as turnbuckles and clasps. Appropriate tools are required to assist in removal. Second, remove the panel and control module so that the charger body can be easily accessed. Avoid damaging any surrounding parts.
1. Connect the network cable from the network port (LAN port) of the optical cat to the WAN port of the router. PS: If your home broadband is an entry broadband network line, there is no use of light cat, then you need to put the entry broadband network line, plugged in the router's WAN interface. The network cable connected from any LAN interface of the router can be plugged into the network port of the computer.
2, the router interface line insertion method is as follows: WAN interface, called Internet interface in some routers, the interface is generally marked with English letters, as shown in the following figure. WAN interface is used to connect the external network device, that is, the network cable used to surf the Internet. In an ordinary wireless router, there are generally four LAN interfaces, and some routers will mark 4 below, and some routers will not mark.
3. Connect the network cable from the LAN port of the optical Cat to the WAN port of the router. If your home broadband does not use light cat, directly use the broadband network line in the home, you need to plug it into the WAN interface of the router. You can choose to connect the network cable from any LAN interface of the router to the network port of the computer. For laptops, you can choose to connect to a routerNo need to use a network cable to connect to the router.