1, Baohua Weijian connected mobile phone is not 100% of the reason is: charging box failure. According to the parameter information query of Baohua Weijian pi7 charging box, Baohua Weijian charging box can not be full because the charging box is faulty. This situation should be the Bluetooth headset battery damage; Go to the Bluetooth headset brand after-sales network detection, or replace the new battery use; Try to protect the battery during use, so as not to damage the battery in advance.
2, whether the question wants to ask "Baohua Weijian pi5 reasons for dissatisfaction "? Electrical contact is poor, electrical internal failure. There are problems with the charging line or the charger itself, such as damage and poor line contact, resulting in unable to transmit the charging current normally, resulting in incomplete charging. The internal battery or circuit of Baohua Weijian pi5 charging treasure is faulty, and the charging current cannot be received and stored normally, affecting the charging effect.
3, the battery is damaged, repair the battery. If the power of Baohua Weijian pi5 keeps dropping, it means that the battery has been damaged and cannot be used normally, so the battery can be replaced or repaired at this time, so that it can be solvedThe power loss problem. When any electronic equipment is found to be faulty, it should be repaired at the first time, so that it can be used normally and will not cause other failures.
4, because the charging status is abnormal or the battery is full. The green light of Baohua Weijian PI7 when charging may be because the charging status is abnormal or the battery is full. You can first check whether the charging cable and charging head are intact, and then try to replace the charging cable and charging head and charge again.
5, Bluetooth signal is unstable, insufficient power. Bluetooth signal is unstable: if the Baohua Weijian device is between the phoneMethod boot, need to replace the battery.
The power switch is not turned on, the battery is insufficient, and the receiver is damaged. Power switch not on: Make sure the power switch of airship 5 is on. Low battery: Check the battery of airship 5, if it is below normal level, it needs to be charged or replaced with a new battery. Receiver damage: If other operations are normal but the indicator is still red, the receiver is faulty.
Can be plugged in and turned on. The quality of Baohua Weijian audio is very good, and this product can be used to optimize the frequency range of different music styles. Each mode uses graphicsBalance technology automatically adjusts the sound balance and enhances the most important sound frequencies in the chosen musical style. Ultimately, digital sound controls allow you to easily and accurately adjust the sound balance to match the type of music you're playing to get the best out of your music.
Baohua Weijian Fei adopts a comprehensive wireless design, canceling AUX and cable USB-C only for system maintenance. On the back of the bottom is the power port, and on the left and right are the reset button and the Service debugging port, which are mainly used for firmware upgrade and maintenance.
Baohua Zeppelin yellow lights keep flashing as long as Baohua WeijianDisassemble the airship and replace the two 16v capacitors inside. The reason why the light has been blinking is that the current is too large, exceeding the specified current limit of the yellow light of the Baohua Zeppelin, as long as the capacitor can be removed to solve the problem.
Baohua Weijian airship red light has been flashing solution. It will disassemble itself, just take it apart and replace the two 16v capacitors inside. Wireless headphones are the middle line is replaced by radio waves, from the computer audio outlet connected to the transmitter, and then sent by the transmitter through the radio wave to the receiving end of the headset, the receiving end is equivalent to a radio. There are three known types of wireless headphones. One is a Bluetooth headset, the other is a Bluetooth headsetInfrared headset, three for 4G.
1, the audio is not charged in the power may be because: if the charging line is plugged in, the charging light is on and the charge is not charged, there is a problem with the audio, and it needs to be sent for maintenance inspection. If the light is not on, it is possible that the charger has a problem, you can replace a charger to try. If the charger is not original, it may be that the polarity of the charger is reversed (positive and negative electrodes are reversed).
2, because the charging status is abnormal orThe battery is full. The green light of Baohua Weijian PI7 when charging may be because the charging status is abnormal or the battery is full. You can first check whether the charging cable and charging head are intact, and then try to replace the charging cable and charging head and charge again.
3, cause: Baohua Weijian pi7 battery damage, system failure. Baohua Weijian pi7 charger cause or poor contact. Solution: Try another charger, or data cable, or clean the charging port. Enter the recover mode, select advancsd advanced mode, select wipeBattery, and clear powerPool marks. Restore factory Settings to check whether the system is faulty. Battery damage can only be sent to repair and replace the battery.
4, Baohua Weijian connected mobile phone is not 100% of the reason is: charging box failure. According to the parameter information query of Baohua Weijian pi7 charging box, Baohua Weijian charging box can not be full because the charging box is faulty. This situation should be the Bluetooth headset battery damage; Go to the Bluetooth headset brand after-sales network detection, or replace the new battery use; Try to protect the battery during use, so as not to damage the battery in advance.