1, interference: check the nearby WiFi or interference Bluetooth, if you go to a certain environment will appear noise, because the nearby WiFi or Bluetooth interference. Damage; Check whether the earphones are damaged or blocked, and clean the earphones. Re-pair: Turn off the Bluetooth of the device, put the headset back in the headphone case, and open the headphone case connection again.
2, solve the current sound airpods solution: It may be the headset hardware failure, it is recommended to contact after-sales maintenance.Maybe there's something wrong with the audio. You can download the audio again. It may be caused by unstable Bluetooth transmission, you can re-pair. Apple AirPods are wireless earphones introduced by Apple on September 8, 2016.
3. Getting a new one isn't much use. It's very troublesome. It's very troublesome. This is a common problem. The technology is unstable. The landlord upstairs is Lizi. Useless feels pretty much the same. Once you use it for a while, it's bound to go wrong. If you cannot use the transparent mode for the product, it may be a problem with the system's own software, which can be solved by restoring the factory Settings, or you can contact customer service.When the amount is exhausted, please charge the charging case and the headset cover for 30 minutes and try again. It is recommended to charge the headset in a suitable environment and avoid charging in a high or low temperature environment. Try to restore the Bluetooth headset to factory Settings.
2, the headset has not been used for a long time, it is recommended that you charge for a period of time to activate the headset. The charging box is out of power (the indicator light is red or not after opening the cover), it is recommended that you charge the charging box first. The charging environment temperature of the headset is not 2 to 40°C (low temperature will reduce battery activity), it is recommended that you charge the headset at normal room temperature.
3, please observe the earphone charging contact and chargingWhether the cartridge charging shrapnel or probe is stained with oil/sweat or dirt, if so, try to clean it with a dust-free cloth or cotton swab. Tip: The charging contact is the only channel for the communication between the charging box and the headset. If the charging contact is poor due to dirt and other reasons, the headset will not be charged in the box, and the headset will be connected continuously with the cover closed.
4, the cause of the fault: no use for a long time to cause the charging box power exhaustion indicator failure Solution: normal charge will be charged to see whether the indicator is normal. Try to restore factory Settings first: place the headphones in the charging case and open the cover, long press the function key (15s) To complete the restoration of factory Settings after the red indicator flashes three times; Plug in the charger again to see if the indicator is back to normal.
1, the earphone charging bin can be cleaned with a fine head face sign dipped in alcohol, or use a toothpick wrapped around non-woven cloth and alcohol to clean. The headphone box can also be cleaned with a lint-free cloth or glasses cloth, and it is better to dip the cloth with a little water when cleaning. If there are stubborn stains, you may wish to add a little toothpaste, which will both clean and remove subtle scratches on the box. blueDental headphones use a semi-in-ear design, which is easier to accumulate dirt.
2, when the Bluetooth headset charging bin accidentally into the water, immediately remove it from the water, because the charging bin usually has a certain sealing, water will not immediately penetrate the electronic circuit. At this time, the paper towel should be used to quickly dry the water outside the charging bin. After the water on the surface is dried, the power supply of the headset should be disconnected immediately. Please note that the battery in most Bluetooth headphone charging pods is not removable.
3, there are many types of earbuds, earbuds can be removed when the earbuds are cleaned, and then pressed on. Sounds like thisHow to clean the earphones, first wipe with toilet paper, and then slightly bump, and pour out the earphones. If you can't clean it up, use one of these cotton swabs, wipe it, or dip it in a little water to suck it out.