1, you can tilt the iPhone downward to avoid further liquid into the device. Then, you can try to gently wipe the lightning connector and charging cable with a clean cloth. ifThe problem still persists and it is recommended to keep the iPhone in a dry area with ventilation. If the liquid is a beverage such as coffee, tea or cola, it is recommended not to attempt to charge it until it is completely dry.
2. Unplug the data cable or accessory, drain the remaining liquid from the iPhone port downward, and make sure that there is no liquid in the golden finger part of the data cable. The charging port is facing down, and the "cold air" of the hair dryer is directed at the charging port of the iPhone for air drying treatment to ensure the air drying of the water, so as not to affect the normal charging. (Or use the back of the hair dryer, against the charging port, to suck the water out). Do not place foreign objects (such as cotton swabs or paper)Cloth) inserted into the lightning connector to prevent debris from falling in.
3, you can use dry air blowing or vacuum cleaner to absorb moisture. Leave it for a while: Leave both the phone and the charging cable for a while, waiting for the internal fluid to drain. This can take several hours, or even longer. Try charging again: After making sure the charging port is dry, try charging the device again. If the problem still occurs, you may need to contact Apple after-sales for further inspection and repair.
4. Power off the device and remove the battery (if it can be removed). If the device cannot remove the battery, disconnect the power supply as soon as possible. Wipe the liquid clean with absorbent paper or a towel and other dry items to avoid further infiltration of liquid into the device. If there is only water stains on the surface, you can put the equipment in a dry and ventilated place to dry, or use a hair dryer to dry at low temperature, avoid using a high temperature hair dryer.
5, you can unplug all cables or accessories, do not insert them until they are completely dry; With the lightning connector facing down, tap the iPhone gently with your hand to drain the remaining liquid; Or place the iPhone in a ventilated, dry area and wait at least 30 minutes before trying to charge it with the lightning cable or try to connect itLightning accessories; If you see the warning again, there is still liquid in the lightning port or under the pin of the lightning cable.
6. The first thing you need to do to dry your IPHONE and LIGHTNING cable is to unplug all cables or accessories from your iPhone and then turn it off. After that, gently shake the iPhone with the port facing down to remove excess water. Meanwhile, wipe the lightning cable with a soft dry cloth. Check the lightning cable for damage The next step is to check the lightning rod for signs of damage. Over time, the usual wear and tear can damage the connector of the lightning cable.
1, certainly not, the principle of wireless charging is electromagnetic induction, wireless power transmission. There's water on the back, there's stuff, there's the shell. At most, it is shielded and cannot be received, but it will definitely not cause damage to either party's equipment. As long as the water doesn't get into the equipment.
2, this is a new function brought by Apple officials to prevent liquid caused by short circuit damage to the machine, if the prompt appearsLiquid has been detected on the lightning connector of your iPhone. You can use cotton swabs, paper towels, etc. to dry the liquid on the lightning port and accessories before charging; Or use wireless charging to charge your phone.
3, the car mobile phone wireless charger is essentially an electronic device, if it encounters water, it may lead to short circuit or circuit damage, resulting in failure to work normally. In addition, electronic devices may generate current after encountering water and cause safety hazards, such as electric shock. If you accidentally put a mobile phone wireless charger in water, do not use it, but take it out as soon as possible and power it off, and then dry the device.
4, is the wireless charger damaged to the phone? No wireless charging technology will not only not damage the phone but also extend the service life of the phone charging interface. The working principle of the traditional charger is different. Wireless charging uses electromagnetic induction technology, which transmits energy through the magnetic field generated by the coil. There is no difference between the two charging methods for the mobile phone battery. Wireless charging introduction: Wireless charging is completely harmless to the human body, there will be no radiation and the like.
5, avoid the spread of water inside the phone. Please do not use a hair dryer or stove to bake after water, so as to avoid liquid flowing into the inside of the phone and high temperatureTreatment to ensure that the water is dried, so as not to affect the normal charging. (Or use the back of the hair dryer, against the charging port, to suck the water out).
2, the Apple phone prompts that the interface can not be charged with liquid, which may be caused by the penetration of liquid into the tail plug, you can clean the tail jack or replace the original charger and data cable. If the problem persists, it is recommended to contact after-sales maintenance.
3, immediately shut down when the phone water, the first thing to do is to shut down the phone or remove the battery. The purpose of doing so is to avoid short circuit of the mobile phone in the case of water and humidity, and damage the internal line and circuit board of the mobile phone. Tissue boxA cotton swab will suck up as much water as possible from the phone and let it dry in the sun for a few days. Especially the headphone jack and charging power port connected to the inside of the phone.
It should be noted that the charging port of the electric toothbrush encounters water is no problem, but if it is stained with water, it can not be charged, otherwise it is easy to cause short circuit, the correct step is to throw the water out in time after the charging port is flooded, and then dry. Normally ifThere is no need to charge, and after water, you can put the electric toothbrush in a dry place to dry the water, or use cotton, napkins and other items to dry the water.
Wireless charging, and even remote sensing charging. Its principle is electromagnetic induction, which is usually used in small power situations and does not require electrode contact points. There are induction coils in the small column and electricity, there are induction coils in the electric toothbrush insertion part, and there are plastic insulation outside, there is no electrical contact, and the induction obtains electricity to charge the battery and drive the small motor.
The basic principle of wireless charging is to convert the current into a magnetic field, which is transmitted through the airAfter the transmission, it is converted into current and transmitted to the intelligent terminal. When the system works, the input end converts the AC mains into direct current through the full bridge rectifier circuit, or uses the 24V direct current end to supply power to the system directly. After passing through the power management module, the output direct current is converted into high-frequency alternating current through the 2M active crystal oscillator inverter to supply the primary winding.
1, Step 1: Stop using the phone immediately If you find water in the Apple charging port, stop using the phone immediately. Because if there's water in the phoneIf you continue to use it, it is likely to cause the phone to short circuit, which will lead to the phone being unable to use. Therefore, after finding the phone water, the first time to turn off the phone, and immediately unplug the charger.
2, the Apple phone prompts that the interface can not be charged with liquid, which may be caused by the penetration of liquid into the tail plug, you can clean the tail jack or replace the original charger and data cable. If the problem persists, it is recommended to contact after-sales maintenance.
3, if the phone charging port water, you can take the following measures: out: the phone out of the water, and take out the battery. Dry: Wipe the surface of the phone with a dry towel or paper towel,Let dry in a cool, ventilated place. Clean the charging port: Use a desiccant or dry cotton swab to clean the charging port. Test: If you can charge normally, there is generally no problem.
4, immediately shut down when the phone water, the first thing to do is to shut down the phone or remove the battery. The purpose of doing so is to avoid short circuit of the mobile phone in the case of water and humidity, and damage the internal line and circuit board of the mobile phone. Use a tissue box cotton swab to drain as much water as possible from the phone and let it dry in the sun for a few days. Especially the headphone jack and charging power port connected to the inside of the phone.
5, Apple mobile phone charging display hasLiquid can not be charged how to solve the Apple mobile phone charging port has liquid, charge not into the electricity look over! Unplug the cable or accessory, drain the iPhone connector downward, and make sure there is no liquid in the golden finger part of the cable.
6, the solution to the water in the charging port of the Apple phone is to wipe with cotton cloth, gently shake, use a hair dryer, use an electric fan, put it in a ventilated place, use a dehumidifier, use a wireless charging version, and set the drainage function of the phone. Wipe with a cotton cloth Dry the iPhone charging port and Lightning charger with a cotton cloth or lint free cloth.